Quick Ford Door Ajar Switch Bypass Guide

You may need to know the Ford door ajar switch bypass method to temporarily avoid the switch replacement.

To bypass the ford door ajar switch, you’ll need to remove the door panel, insert a wire into the latch pigtail’s terminals, and secure it with some tape.

You won’t get any negative message on the dashboard or warning light for a while. This could help until you find the means to arrange for the Ford door ajar switch replacement.

In this guide, I’ve actually broken down the whole process into simple steps for you to easily follow at the moment of emergency. Enjoy!

The Ford Door Ajar Switch Bypass Technique!

To fix the issue of the door ajar warning light or light turning on, you can try this bypass method. Based on the door side, the process will be a little different. Also, make sure you know exactly how to locate the ford door ajar switch.

Bypass Ford Driver’s Side Door Ajar Switch

If you want to bypass the driver’s side door ajar switch in your Ford car, here’s what you need to do:

• Firstly, remove the door panel from your driver’s side door. To know the procedure in detail, check this guide about replacing the Ford door ajar switch where I’ve shown it.
• Then, pull the insulation of the door and slide it aside. To keep it like this, you can use tape or clip.
• Afterward, locate the door latch pigtail and ensure to check the number of it. Based on the number of pigtails, the method will be different:

• Now, if you see one pigtail on the door lock latch inside the hole, use a wire and cut its edge slightly so that only the metal part remains.
• Then, insert the wire’s metal part on one terminal and another part on another terminal.
• After that, use tape to lock its position and ensure the door ajar switch is bypassed properly without disabling other features.

• Then again, if you see two pigtails on the door lock latch, cut 2 wire’s edges and ensure to expose the metal parts only.
• Afterward, use the wire’s metal part on the right side of both pigtail’s right terminals (just like the image above).
• Next, do the same thing on the left side. Just insert both wire’s edges to the right terminal of both pigtails.
• After that, use tape to seal the wire into a fixed position before putting on all the removed parts.

Duration: 20 minutes.

Bypass Ford Passenger’s Side Door Ajar Switch

If your passenger’s side door ajar switch shows issues, here’s how you can bypass it most easily:

• To begin with, take out the door panel.
• Then, pull the insulation that hides the interior gears of the door.
• After that, locate the door lock latch’s pigtail and inspect its thick wiring harness.
• Next, use a pocket knife to cut the black insulation that hides the inner wires.
• Once you do this, you’ll find 4 wires that have different shades: pink/yellow with black strips, pink with orange strips, and two black wires.

• After that, cut the two black wires and secure the exposed edge using tape or wire caps.
• Lastly, reinstall all the removed parts.

Duration: 20 minutes.

Wrapping Up

The Ford door ajar switch bypass trick is pretty simple once you know the instructions well. It doesn’t need special tools or skills for the project.

While this temporary emergency hack can save the day, replacing the switch is crucial for a permanent fix. So, I hope you don’t take the bypass as a long-lasting fix, because it’s not. Your safety and vehicle functionality come first.

Thanks for reading and I will be back with more door ajar stuff.